3D Printed Butter Mold that produces Christmas Tree Shaped butter.

Printed with made in USA Atomic Brand PLA Filament. Colors may vary; but will likely be either light gray, green, or red. Printed with 30% infill.

This mold produces a Christmas Tree butter shape approximately 3 inches tall and 2 inches diameter at its widest point.

To use: start with softened butter...
This mold uses approximately 3 tablespoons of butter.
Line the mold with plastic wrap. Fill both sides with softened butter, connect the two halves. Then put in freezer for approximately 20 minutes after you press in the butter. Remove from freezer and then remove molded shape. Hand wash only. Item is re-usable.

Note about "Infill Percent".. I have been offering these with 30% infill, which makes the item heavier and more durable. On a trial basis, I am offering an economy version., with only 15% infill. Since the 15% infill option takes less material, I can offer it at small discount, but it is not going to be as strong as the 30% version.

This is Thingiverse thing: 4024890   
Designer: R.Kevin Ball 
License: Attribution 4.0 International (CC BY 4.0)